La Rosa della Conoscenza
Conoscenza e formazione per tutti...  
 
     
HOME AREE TEMATICHE
HOME BIBLIOTECA
PRESENTAZIONE
BIBLIOTECA
SAGGI, TUTORIAL E CORSI
LINK UTILI



Indice Saggio
0. Abstract
1. Introduction
2. Experimental procedures
3. Results and discussion
4. Conclusions
5. References


Sito certificato da:
ICRA



Ottimizzato con Ranking-Hits

Novità:
Introduzione alle figure retoriche nella lingua italiana - Damiano Martorelli
Disponibile su
LaFeltrinelli.it

   

Lubricated Rolling-Sliding damage
in powder metallurgy alloys

by prof.ing. Giovanni Straffelini, dr.ing. Damiano Martorelli
Department of Materials Engineering, University of Trento, Via Mesiano 77, 38122 TRENTO (Italy)
E-mail: Giovanni.Straffelini@ing.unitn.it

5.1 References

[1] F.J. Esper and C.M. Sonsino, "Fatigue Design for PM Components", EPMA, Shrewsbury, England, 1994.
[2] G.F. Bocchini, Int. Journal Powder Metallurgy, vol. 22, 1986.
[3] S.C. Lim and J.H. Brunton, Wear, vol. 113, 1986.
[4] A.I. Taskinen and M.H. Tiakkanen, Modern Development in Powder Metallurgy, vol.17, 1984.
[5] K. Lipp, C.M. Sonsino, D. Pohl and S. Hock, Proceedings of the 1998 Powder Metallurgy World Congress and Ehibition, Granada, Spain, EPMA, UK, vol.3, 1998.
[6] G. Hoffman, K. Lipp, K. Michaelis, C.M. Sonsino and J. Rice, Int. Journal Powder Metallurgy, vol. 35, 1999.
[7] D. Martorelli, Thesis in Materials Engineering, University of Trento, 1997.



[8] J.A. Williams, I.N. Dyson and A. Kapoor, J. Mater Res., vol. 14, 1999.
[9] S. Carabajar, C. Verdu and R. Fougeres, Materials Science Engineering A, vol. 272, 1999.
[10] J.O. Smith and C.K. Liu, Journal Applied Mechanics, vol. 20, 1953.
[11] T.J. Griffiths and A. Ghanizedeh, Powder Metallurgy, vol. 29, 1986.
[12] D. Pohl, Powder Metallurgy International, vol. 1, 1969.
[13] B. Kubicki, Powder Metallurgy, vol. 38, 1995.
[14] D. Nelias, M.L. Dumont, F. Cohuer, G. Dudragne and L. Flamand, ASME Journal of Tribology, vol. 120, 1998.
[15] T. Bell and Y. Sun, Surface Engineering, vol. 6, 1990.
[16] I.A. Polonsky, T.P. Chang, L.M. Keer and W.D. Sproul, Wear, vol. 208, 1997.
[17] G. Straffelini, A. Molinari and H. Danninger, Materials Science Engineering A, vol. 272, 1999.


 
     
  Contatto | ©2008-2014 DM Paideia. All rights reserved. Powered by DM Services